Adding Water / problems

Gameplay
1

Evening all

Iv got a large ares too fill with water but the Large wet stones don’t do the job, Once the touch each other they just stop and now i cant add anymore water, Anyone have any ideas would be a huge help.

image
image.png1920×1080 466 KB

2

I ran into this problem with one of my builds and found the way to deal with the lack of filing was to subdivide the carved out bits into smaller chunks and then add the wetstones. You could probably make temporary walls in your larger areas then destroy them once the area has filled up.

3

OK np i will try that out, Thank you

4

Reverse of how the Netherlands got taken from the sea, I give it a thumbs up as a Dutchman :stuck_out_tongue:

5

One thing I’ve found is that if water “sticks” you need to totally cover the surface it’s stuck on to get it to flow properly again. I suspect that in the case where water is stuck on multiple levels, it’s not possible to do that anyway; so the sub-division method looks like both the fastest and most reliable option.

6

Loaded the game back up to try this and for some reason the game runs soooo slow and no one will do anything at all, All im getting now is below.

image
image.png1920×1080 341 KB

Jumps from that to idle, reloaded the game a couple of times and still the same

7

Do you have a save before you added the water? You may need to go back to that or remove wetstones. Flowing/moving water is computationally expensive.

8

i will try that when i get 5 min, Thanks