Draining lakes leave sheets of water on top of blocks

[Yosmo78]

Draining lakes leave sheets of water on top of blocks

Summary:
I built a mine shaft straight into a lake to drain it and it left sheets of water on top of blocks where there were suppose to be no water
Steps to reproduce:

1. find a lake, I found mine in the desert
2. then near the lake build a long mine shaft, then mine straight towards the lake
3. empty the lake to find this bug

Expected Results:
empty lake no water tiles
Actual Results:
blocks with sheets of blue covering them
Notes:

Versions and Mods:
Latest Alpha 13
System Information:

[jomaxro]

Still an issue #a15r549::tag.

[SirAstrix]

Issue is back in release-572 (x64).

[groms]

Try this, have at least one full block to be free of water.

[SirAstrix]

@groms

least one full block to be free of water

If you replace a block with water, ti goes away. If you remove terrain on top of a block that doesn’t have water, it doesn’t fill in. And it can be covered up as well.

Regardless, it’d look a lot nicer if it weren’t there. And we almost had that a couple updates ago.

Water Clipping On Low Levels

Summary: It’s been talked about before that when the water level is lowered, it left a small blue film on the top of blocks. That was talked about being fixed, but now it’s causing a clipping effect. Steps to reproduce: Find water source. Dig bottom of it out. Lower till top water level is below top block. Expected Results: Sand or grass to be visible. Actual Results: [image] Notes: Version Number and Mods in use: Develop 2940 (x64)